Washer shows E67 and will not start; often after power surge or incorrect mains frequency/voltage

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Incorrect mains frequency or voltage, Surge-damaged control board, Incorrectly configured PCB, Internal power supply fault

Safety first: Unplug the washer. Do not attempt to modify mains supply yourself.

Steps to check and address E67:

Verify supply: Ensure the washer is connected to a properly grounded outlet with the correct voltage as per the rating plate.
Power reset: Leave unplugged for 15 minutes, then reconnect. If E67 returns immediately, internal damage is likely.

When to call a technician: E67 typically requires control board replacement or reprogramming by Siemens service.

Professional Required 5/5

Main Control Board

Check Price on Amazon

We may earn a commission from links on this page.