E dL
Speed Queen
Door Lock Error (Front-Load)
Front-load Speed Queen washer shows E dL and will not start; door will not lock.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective door lock assembly, Broken door strike, Loose door lock wiring, Failed control board door lock relay
How to Fix / Troubleshooting
Safety: Disconnect power before removing the front panel or door lock.
- 1. Inspect door strike: Check the plastic strike on the door for cracks or missing pieces. Replace if damaged.
- 2. Check door alignment: Ensure the door closes fully and latches without lifting or forcing. Adjust hinges if sagging.
- 3. Access door lock: Remove the front panel or door boot clamp to reach the door lock assembly. Inspect for burn marks or broken plastic.
- 4. Verify wiring: Confirm the harness is firmly connected and not pinched by the cabinet. Repair any damaged wires.
- 5. Replace door lock: If the lock does not engage or test properly with a meter, install a new Speed Queen-compatible door lock assembly.
- 6. Control board check: If a new lock does not resolve E dL, the main control board may not be powering the lock. Professional diagnosis is recommended.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements