Front-load washer shows E FL; door failed to lock at start of cycle.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Weak door lock solenoid, Misaligned door strike, Loose wiring to door lock, Control board not energizing lock

Safety: Disconnect power before servicing the door lock.

1. Confirm door closure: Ensure no clothing is caught between door and gasket. Close door firmly.
2. Inspect strike and latch: Replace a worn or broken door strike. Adjust hinges if needed.
3. Check wiring: Access the door lock and verify the harness is secure.
4. Replace door lock: If the lock coil is open or the mechanism is weak, install a new door lock assembly.
5. Control board: If E FL persists, the control may not be sending voltage to the lock; technician diagnosis is advised.

Medium 3/5

Door Lock Assembly

Check Price on Amazon

We may earn a commission from links on this page.