Washer does not fill with enough water; clothes barely covered even on deep fill settings.

Safety: Unplug the washer before accessing internal components.

• 1. Verify settings: Ensure the cycle and water level options are set to the desired level (e.g., deep fill if available).
• 2. Clean pressure hose: Access the pressure sensor and remove the hose. Clear any soap residue or debris and reinstall securely.
• 3. Check inlet flow: Confirm both hot and cold valves are fully open and inlet screens are clean.
• 4. Recalibrate (if supported): Some models allow a water level calibration via service mode; follow the service manual procedure.
• 5. Replace pressure sensor: If levels remain low, replace the water level/pressure sensor.