E32
Zanussi
Pressure Sensor Calibration / Signal Error
Washer intermittently shows E32, often during spin, with incorrect load sensing or water level behavior.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Mis-calibrated pressure sensor, Electrical noise on sensor wiring, Loose connector at sensor or PCB, Faulty main control board
How to Fix / Troubleshooting
Safety: Unplug the appliance before accessing internal components.
- Check wiring harness: Inspect the cable from the pressure sensor to the control board for pinched sections or damage. Reseat both ends of the connector.
- Ensure correct hose routing: Confirm the pressure hose is not rubbing against moving parts or kinked, which can cause erratic readings.
- Run a reset: Some Zanussi models allow a reset by unplugging for 10–15 minutes, then running a rinse and spin cycle with no load to re-establish baseline levels.
- Replace pressure sensor: If E32 continues, replace the pressure sensor with the correct Zanussi part number.
Persistent E32 after sensor replacement usually indicates a control board issue that should be handled by a professional.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements