Washer intermittently stops during spin with E54, sometimes resuming after a pause.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Sticking motor relay on PCB, Pitted relay contacts, Loose relay solder joints, Excessive motor current draw

Safety: Disconnect power and do not bypass any safety devices.

Inspect PCB: Remove the control board and look for cracked solder joints or heat damage around the motor relay. Reflowing solder or replacing the board is typically required.
Check motor load: Ensure the drum turns freely by hand and that bearings are not seized, as high load can stress the relay.

Because E54 involves high-current components, repair is best left to a professional who can replace the control board safely.

Professional Required 5/5

Main Control Board

Check Price on Amazon

We may earn a commission from links on this page.