State Blower Motor / Power Vent Failure

State electronic gas tank-type water heater LED flashes E6; unit may not power the blower.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed blower motor, Loose blower wiring, Faulty blower relay in gas control

Safety: Disconnect power before servicing the blower.

Check wiring: Inspect the blower power connector and harness for damage. Reseat connectors.
Spin test: Verify the blower wheel spins freely by hand.
Voltage test: A technician can test for proper voltage at the blower when a call for heat is present. Replace the blower if voltage is present but it does not run. If no voltage, the gas control or control board may be faulty.

Hard 4/5

Draft Inducer Blower

Check Price on Amazon

We may earn a commission from links on this page.