Brine tank full of water and not draining during regeneration

Safety first: Disconnect power and be prepared for water spillage when working on the brine tank.

• Lower water level: Manually remove excess water from the brine tank with a jug or wet vacuum to below the safety float level.
• Check safety float: Remove the brine well cover and ensure the float moves freely. Clean any salt sludge and verify the float drops fully when water level is low.
• Inspect brine line: Remove the brine line from both the valve and the brine well. Blow through to confirm it is clear. Replace if blocked.
• Clean injector: Remove and clean the venturi injector and associated screens in the Monarch valve.
• Reassemble and test: Refit all components, restore power and water, and run a manual regeneration while observing brine draw.