Brine tank has very little or no water before regeneration (appears dry)

Safety: Disconnect power and avoid inhaling salt dust when working in the brine tank.

• Check refill cycle: Observe a regeneration and confirm that water enters the brine tank during the refill stage. If not, suspect the refill circuit.
• Inspect brine line: Ensure the hose from the valve to the brine well is not kinked or blocked. Flush with warm water if necessary.
• Clean refill orifice: Remove the brine valve assembly and clean the small refill orifice and flow control. Scale or debris can block this passage.
• Verify settings: Confirm the salt dosage or refill time is set correctly for your Tapworks model and salt type.
• If no water flows even after cleaning: Replace the Tapworks brine valve assembly.