Water2Buy softener does not start regeneration at the programmed time (no error displayed)

Safety first: No plumbing work is required for this check.

• Verify current time: Enter the time-setting menu and correct the current time and day.
• Check regeneration mode: Confirm whether the unit is set to time-based or metered regeneration and adjust according to your needs.
• Review regeneration time: Ensure the regeneration start time is set to a future time (usually 2:00 AM) and not disabled.
• Check for vacation mode: Some Water2Buy controllers have a vacation or hold mode. Disable it if active.
• Monitor next cycle: After adjustments, observe whether the next scheduled regeneration occurs. If not, the control board may need replacement.