Balay Condenser Fan Failure

Condenser fan at the rear does not run, causing the compressor area to become very hot.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed condenser fan motor, Obstruction preventing fan rotation, Loose or burnt fan connector, Faulty fan control on PCB

Safety: Unplug the unit before working at the rear.

Inspect fan: Remove the rear panel and check if the fan spins freely by hand. Remove any debris.
Check wiring: Ensure the fan connector is secure and wires are intact.
Test motor: Measure resistance across the motor terminals. An open circuit indicates a failed motor.
Replace fan: Install a Balay-compatible condenser fan motor if defective.
Control board: If the motor is good but never receives power when the compressor runs, the PCB may need replacement.

Medium 3/5

Condenser Fan Motor

Check Price on Amazon

We may earn a commission from links on this page.