BODEGA43 Cooling System Disabled While Control Powered

Compressor and fans do not run, but the display and interior light work normally.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed compressor relay on PCB, Safety thermostat open, Control board in demo mode, Faulty temperature sensor preventing call for cooling

Safety: Unplug before accessing the control board.

Steps:

Check mode: Ensure the unit is not in showroom/demo mode (refer to BODEGA43 manual for exit procedure).
Adjust setpoint: Lower the set temperature to force a cooling demand.
Sensor check: Test cabinet sensor; if it reads extremely low, the control may think no cooling is needed.
Control board: Inspect and, if necessary, replace the main control board if the compressor relay does not energize when cooling is demanded.

Hard 4/5

Main Control Board (PCB)

Check Price on Amazon

We may earn a commission from links on this page.