Brandt
Failed Compressor Start Components
Clicking sound every few minutes, compressor attempts to start but immediately stops.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective start relay/PTC, Weak compressor, Faulty overload protector, Low supply voltage
How to Fix / Troubleshooting
Safety first: Unplug the cooler before working on the compressor electricals.
Steps to resolve repeated clicking:
- 1. Verify supply voltage: Ensure the outlet provides stable voltage within Brandt's specified range.
- 2. Access compressor: Remove the rear panel and locate the start relay/PTC and overload protector on the compressor terminals.
- 3. Inspect and test relay: Remove the relay/PTC and check for burn marks or rattling. Test continuity according to specifications. Replace if defective.
- 4. Check overload: Test the overload protector for continuity when cool. Replace if open or physically damaged.
- 5. Compressor test: If new start components do not resolve the issue, the compressor windings may be failing. This requires professional sealed system service.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Compressor Start Relay / PTC
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements