E5
Climadiff Compressor Overload / High Temperature Protection Fault

Display shows E5 and the compressor or fans may not start or may shut down quickly.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Overheated compressor due to poor ventilation, Faulty compressor thermal protector, Blocked condenser coil or failed condenser fan, Main PCB compressor drive fault

How to Fix / Troubleshooting

Safety: Unplug the unit. The compressor and condenser can be very hot; allow them to cool before touching.

  • Check ventilation: Ensure the Climadiff wine cooler has the required clearance at the rear and sides and that front or rear grilles are not blocked by dust or cabinetry.
  • Clean condenser: Remove the rear panel and gently vacuum or brush dust from the condenser coil. A clogged condenser causes overheating.
  • Inspect condenser fan: On compressor models with a fan, verify that the fan spins freely and is not obstructed. Replace the fan motor if it does not run when powered.
  • Check thermal protector: The compressor overload/thermal protector (often clipped to the compressor body) can fail. With power disconnected, test continuity; replace if open when cool.
  • Allow full cool-down: Let the compressor cool for at least 30–60 minutes, then restore power and observe operation.
  • If E5 persists: The main PCB may be misreading compressor current or temperature. At this stage, professional diagnosis of the compressor and control board is recommended.
Advertisements

Repair Difficulty

Hard 4/5

Required Part

Compressor Overload Protector
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements