E16
Electrolux Compressor Protection / High Current Fault

Display shows E16 and the unit may not cool; compressor may not start.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Shorted compressor windings, Incorrect or failed start device, Shorted wiring harness to compressor, Faulty compressor driver on control board

How to Fix / Troubleshooting

Safety: Unplug the wine cooler before accessing the compressor. Only qualified persons should test compressor windings.

Steps:

  • 1. Visual inspection: Remove rear access panel and inspect compressor area for burnt smells, melted insulation, or charred components.
  • 2. Check wiring: Ensure no wires are pinched or shorted to the cabinet or compressor shell.
  • 3. Inspect start device: Replace the compressor start relay/overload with the correct Electrolux part if it shows signs of overheating or damage.

Important: Testing compressor windings and replacing a compressor require specialized tools and EPA-certified handling of refrigerant. If E16 persists after replacing the start device and verifying wiring, contact a professional technician.

Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Compressor Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements