Display shows E7 and the condenser fan at the rear may not operate, causing the cabinet to overheat.

Safety first: Unplug the wine cooler before removing the rear panel. The condenser coil and fan may have sharp edges.

E7 is often associated with the external condenser fan that cools the compressor and condenser coil.

• Step 1 – Inspect ventilation: Ensure there is adequate clearance around the rear and sides of the unit as specified by EuroCave. Poor ventilation can overheat the system.
• Step 2 – Access the condenser fan: Remove the lower rear cover to expose the condenser coil and fan assembly.
• Step 3 – Clean the condenser: Use a soft brush and vacuum to remove dust from the condenser fins. Do not bend the fins.
• Step 4 – Check fan operation: Spin the fan blades by hand; they should move freely. Look for cable ties, insulation, or debris blocking movement.
• Step 5 – Inspect wiring and connector: Reseat the fan connector and check for corrosion or heat damage.
• Step 6 – Replace fan if needed: If the fan does not run when the compressor is on (and power to the fan is confirmed by a qualified person), replace the condenser fan motor with the correct EuroCave part.
• Step 7 – Reassemble and test: Refit the rear cover, restore power, and verify that E7 clears and the fan runs whenever the compressor operates.