Wine cooler runs but does not get cold enough; compressor and fans operate but temperature remains high.

Safety: Unplug the unit before cleaning or inspecting components. Sealed system repairs must be done by licensed technicians.

Steps:

• Clean condenser: Move the cooler away from the wall. Remove the rear lower panel and thoroughly clean the condenser coil with a brush and vacuum.
• Check ventilation: Ensure there is adequate clearance around the unit per Fagor's installation instructions. Poor airflow can severely reduce cooling.
• Verify door seal: Inspect the door gasket for gaps or damage. Close the door on a sheet of paper; you should feel resistance when pulling it out all around the perimeter.
• Monitor frost pattern: After running for 20–30 minutes, carefully remove the interior rear panel and observe the evaporator. A healthy system will show even frost across most of the coil. Frost only at the inlet or no frost at all suggests a sealed system issue.
• Call a professional: If cleaning and gasket checks do not restore proper cooling and the frost pattern is abnormal, a refrigerant leak, restriction, or weak compressor is likely. These require specialized tools and must be handled by a certified refrigeration technician.