F6
Ivation
Peltier Cooling Module or Driver Fault (Thermoelectric Models)
Display shows F6 and the Peltier (thermoelectric) module does not cool.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed Peltier module, Loose heatsink or thermal paste failure, Burnt Peltier wiring, Control board Peltier driver failure
How to Fix / Troubleshooting
Safety: Unplug the thermoelectric Ivation wine cooler before servicing. The heatsinks can be sharp and hot.
Steps:
- Access Peltier assembly: Remove the rear panel to expose the Peltier module sandwiched between internal and external heatsinks with fans.
- Inspect wiring: Check the Peltier module’s power wires for burns or disconnection. Ensure connectors are secure on the control board.
- Check heatsink contact: Verify that the module is clamped tightly between heatsinks. Loose screws can cause overheating and failure.
- Test module: With a multimeter, check for continuity across the Peltier module. An open circuit indicates a failed module.
- Replace module: Remove the clamping screws, carefully separate the heatsinks, clean old thermal paste, and install a new Ivation Peltier cooling module with fresh thermal compound. Reassemble tightly.
If F6 persists with a new module, the control board’s Peltier driver may be defective.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Peltier Cooling Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements