Excessive frost or ice buildup on the back wall or evaporator inside the wine cooler.

Safety: Unplug the unit before defrosting or removing panels. Do not use sharp tools to chip ice.

Steps:

• Manual defrost: Remove all bottles, unplug the cooler, and leave the door open until all ice melts. Place towels to catch water.
• Check door gasket: Inspect for gaps or tears. Replace with a Ivation door gasket if damaged.
• Inspect defrost components (if applicable): On compressor models with automatic defrost, access the evaporator and check the defrost sensor and heater for continuity. Replace faulty parts with Ivation defrost sensor or Ivation defrost heater.
• Clear drain: Locate the drain hole at the bottom of the evaporator tray and clear any blockage with a soft brush or pipe cleaner.

After reassembly, monitor for recurring frost. Persistent issues may indicate a control board defrost timing problem.