Wine cooler runs but does not get cold enough; temperature stays above setpoint with no error code.

Always unplug the unit before cleaning or servicing.

• 1. Verify setpoint and mode:
  • Confirm the temperature is set correctly for wine (typically 41–64°F depending on zone).
• 2. Clean condenser:
  • Remove the front or rear grille.
  • Brush and vacuum dust from the condenser coil thoroughly.
• 3. Check condenser fan:
  • Plug in and observe the condenser fan motor when the compressor runs.
  • If the fan is slow or not spinning, replace it.
• 4. Inspect door gasket:
  • Look for gaps, tears, or hardened sections of the door gasket.
  • Replace the gasket if it does not seal tightly all around.
• 5. If still not cooling:
  • Feel the evaporator panel inside; if only a small section is cold or there is no frost pattern, the unit may have a refrigerant leak or weak compressor. This requires a licensed technician for sealed-system diagnosis and repair.