Maytag
Improper Temperature Control or Oversensitive Sensor Placement
Wine cooler cycles on and off very frequently (short cycling).
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Thermistor located too close to evaporator, Control hysteresis too narrow, Ambient temperature fluctuations, Oversized compressor for cabinet volume
How to Fix / Troubleshooting
Safety: Unplug the unit before moving sensors or accessing the control board.
- 1. Verify installation: Ensure the cooler is not installed in a location with extreme temperature swings (near ovens, vents, or direct sun).
- 2. Check thermistor placement: Confirm the cabinet sensor is mounted where specified, not touching the evaporator or walls. Reposition if necessary.
- 3. Allow load stabilization: After loading bottles, allow 24 hours for temperature to stabilize before judging cycling behavior.
- 4. Control board update: If available, install an updated control board with improved cycling logic (consult Maytag parts documentation).
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Cabinet Temperature Thermistor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements