E10
Siemens High-Pressure or Refrigeration System Protection Error

Display shows E10; compressor does not start and unit remains warm.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Blocked condenser airflow, Severely dirty condenser coil, Faulty high-pressure protection sensor (if equipped), Main PCB detecting abnormal compressor current

How to Fix / Troubleshooting

Safety first: Unplug the unit before cleaning or accessing the rear compartment.

Steps to address E10:

  • Check ventilation: Ensure the wine cooler has the required clearance around the sides, top, and rear as specified by Siemens. Built-in units must have proper ventilation grills unobstructed.
  • Clean condenser: Remove the rear lower panel and clean the condenser coil thoroughly with a soft brush and vacuum.
  • Check ambient temperature: Verify the cooler is not installed in an excessively hot environment (e.g., next to an oven or in direct sunlight), which can trigger protection.
  • Power reset: After cleaning and improving ventilation, unplug for 10 minutes, then reconnect and monitor operation.

If E10 returns quickly, there may be a sealed-system issue (overcharge, restriction) or a faulty protection sensor/PCB. These require specialized tools and should be handled by a refrigeration technician.

Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Condenser Coil / High-Pressure Protection Sensor
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements