Wine cooler runs but does not get cold enough; temperature remains above setpoint.

Safety: Unplug the unit before cleaning coils or accessing the rear compartment.

Steps:

• Clean condenser: Remove toe-kick or rear panel and gently brush/vacuum dust from condenser coils.
• Check condenser fan: Confirm the fan runs whenever the compressor is on. Replace the fan motor if it does not run and has proper voltage.
• Inspect door gasket: Close the door on a sheet of paper and pull it out around the perimeter. If it slides out easily, the gasket may be leaking and should be replaced.
• Check installation: Ensure adequate ventilation space around the unit and that it is not installed near heat sources.
• Sealed system: If coils are clean, fans work, and gasket is good but cooling is still poor, a sealed system issue (refrigerant leak or weak compressor) is likely and requires professional service.