Wine cooler interior is too cold; bottles near the back may partially freeze even at normal setpoint.

Safety first: Unplug the unit before accessing internal panels or the control board.

Steps to check and fix:

• 1. Verify with a separate thermometer: Place an accurate thermometer in the middle of the cabinet to confirm actual temperature versus display.
• 2. Adjust setpoint: Increase the set temperature by a few degrees and monitor. If the cabinet remains too cold, continue diagnosis.
• 3. Inspect cabinet sensor: Access the interior rear panel and locate the NTC sensor. Ensure it is positioned correctly and not pressed directly against the evaporator, which can cause false low readings.
• 4. Replace sensor if suspect: If the sensor is out of specification or physically damaged, install a new Vestfrost-compatible NTC.
• 5. Check compressor relay: On the main PCB, inspect the compressor relay for welded contacts. If the compressor does not cycle off when it should, replace the control board.