EC9
Wolf
EEPROM / Control Memory Error
Display shows EC9 and the unit may shut down or run erratically after power disturbances.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control board firmware, Voltage spike or surge damage, Failed memory chip on main control, Poor grounding of appliance
How to Fix / Troubleshooting
Safety: Turn off power at the breaker before accessing the control board.
- Power cycle: Disconnect power for at least 15 minutes to allow capacitors to discharge, then restore power. Sometimes this clears minor memory errors.
- Check grounding: Verify the outlet is properly grounded and that the power cord ground pin is intact.
- Surge protection: If EC9 occurred after a storm or outage, consider using a high-quality surge protector rated for appliances once the unit is repaired.
- If EC9 persists: The main control board firmware or memory is likely damaged. Replace the main control board with the correct Wolf part number for your model.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements