Gourmia Control logic or relay drive failure

Timer counts down but fan and heater do not run; unit appears on but idle.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Stuck or failed relays on main control board, Firmware glitch, Loose connectors to fan and heater

Safety first: Unplug before opening the housing.

Reset unit: Unplug for 10 minutes, then plug back in and try again.
Check basket switch: Ensure the basket microswitch is engaging; if the board thinks the basket is open, it may run the timer only.
Inspect connectors: Open the unit and verify that fan and heater connectors are firmly attached to the main control board.
Board replacement: If wiring and switches are good but the board never energizes the fan or heater, replace the main control board.

Hard 4/5

Main Control Board

Check Price on Amazon

We may earn a commission from links on this page.