No water or detergent sprays onto the carpet, but the pump motor can be heard running.

Safety first: Unplug the unit before removing any hoses or nozzles.

• 1. Verify tank levels: Ensure the clean water and detergent tanks are filled and properly seated.
• 2. Clean spray nozzles: Remove the floor nozzle and soak the spray bar in warm water. Use a soft brush or pin to clear each jet.
• 3. Straighten hoses: Inspect the clear solution hoses for kinks or sharp bends, especially near the hinge points. Reroute or replace hoses as needed.
• 4. Bleed air from system: Refill the tank, then with the unit on and over a sink or bucket, hold the trigger continuously for 1–2 minutes to purge air from the lines.
• 5. Check in-line filter: Some Beko models have a small mesh filter in the solution line. Remove and rinse it to restore flow.