Henry Solution Valve Not Closing

Solution dripping continuously from floor tool even when trigger is released

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Worn trigger valve in wand, Debris in solution valve seat, Sticking solenoid valve (if fitted), Excessive pump pressure

Safety: Unplug before dismantling wand or valve assemblies.

Flush system:
- Run warm clean water through the system to dissolve detergent build-up.
Inspect wand trigger valve:
- Open the wand handle where the trigger is located.
- Check the small valve and spring for debris or wear.
- Clean and, if necessary, replace the wand trigger valve assembly.
Check solenoid valve (if present):
- Some models use an electric solenoid valve near the pump.
- Ensure it is not stuck open; replace the solution solenoid valve if faulty.

Medium 3/5

Wand Trigger Valve Assembly

Check Price on Amazon

We may earn a commission from links on this page.