E05
Calphalon
Brew Basket / Carafe Position Sensor Error
Display shows E05 and the brew cycle will not start or stops with beeping.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Carafe not fully seated on warming plate, Drip-stop lever not fully open, Brew basket not latched, Faulty carafe presence microswitch
How to Fix / Troubleshooting
Safety first: Unplug the coffee maker before reaching under the brew basket or around the warming plate.
- Check carafe position: Slide the glass or thermal carafe fully back so it is centered on the warming plate. Some Calphalon models use a carafe presence switch under the plate that must be depressed.
- Inspect drip-stop mechanism: Open the top lid and remove the brew basket. Verify the spring-loaded drip-stop plunger moves freely and is not jammed with coffee grounds. Rinse the basket and plunger thoroughly.
- Reinstall brew basket: Insert the basket so it sits flat and the handle aligns correctly. Close the lid firmly until it clicks.
- Test without coffee: With an empty basket and carafe in place, plug the unit back in and start a small brew cycle. If it runs, the issue was mechanical alignment.
- If E05 remains: The carafe or basket microswitch may be defective or misaligned inside the housing. This requires disassembly to adjust or replace the switch; seek professional service.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Carafe Presence Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements