AEG Control Panel / Power Switch Failure

Vacuum does not respond to power button, but battery indicator lights when placed on charger

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Faulty power button switch, Damaged keypad PCB, Loose internal connector between keypad and main PCB, Firmware lockup

How to Fix / Troubleshooting

Safety first: Remove the vacuum from the charger and, if possible, remove the battery before attempting resets.

  • Step 1 – Attempt reset: With the battery removed (or vacuum off the charger), hold the power button for 10–15 seconds, then release. Reinstall the battery and try again.
  • Step 2 – Check for stuck buttons: Press the power and mode buttons repeatedly to ensure they are not physically stuck.
  • Step 3 – Verify battery charge: Confirm that the battery is fully charged by leaving it on the AEG charger until the indicator shows full.
  • Step 4 – If still unresponsive: The keypad PCB or internal wiring is likely faulty. This requires disassembly and repair by an authorised AEG technician.
Advertisements

Repair Difficulty

Hard 4/5

Required Part

AEG Keypad / Control Panel PCB
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements