Eureka Battery Indicator LED / Display Fault

LED battery indicator does not light during charging, but the vacuum still charges and runs.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Failed LED on battery or body, Loose LED connector, Faulty display PCB, Minor firmware glitch

How to Fix / Troubleshooting

Safety first: Unplug the charger and remove the battery before opening any housings.

Steps to try:

  • Confirm actual charging: Time the charge and then test runtime. If runtime is normal, charging is working despite the indicator issue.
  • Power reset: Remove the battery for 5 minutes, then reinstall and check the indicator again.
  • Inspect LED board (advanced): Open the battery casing only if the design allows safe access (many are sealed and should not be opened). For body-mounted indicators, open the housing and check the LED board connection.
  • Replace display/indicator module: If LEDs are burnt out or the board is damaged, replace the indicator PCB or battery pack.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

LED Indicator PCB
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements