Henry Excessive Brush Drag or Incorrect Head Setting

Vacuum is difficult to push on carpets

Advertisements

Possible Causes

Brush bar set too low or bristles too stiff for carpet, Debris jammed in floor head wheels, Using hard floor mode on deep pile carpet, Worn or seized floor head wheels

How to Fix / Troubleshooting

Safety first: Remove the battery pack before inspecting the floor head.

Step-by-step:

  • 1. Check head mode: If your Henry cordless head has a carpet/hard floor selector, set it to carpet mode.
  • 2. Inspect wheels: Turn the head over and spin the wheels. Remove hair and fibres wrapped around the axles.
  • 3. Check brush bar height (if adjustable): Some heads allow height adjustment. Raise the head slightly for deep pile carpets.
  • 4. Reduce suction (if possible): Use a lower power mode or open any suction relief vent on the handle to reduce drag.
Advertisements

Repair Difficulty

Very Easy 1/5

Required Part

Henry Cordless Floor Head Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements