OKP Orientation / Safety Cutoff or Loose Connection

Vacuum shuts off when tilted to certain angles or when lifted.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Loose battery contacts, Damaged tilt sensor, Broken internal wiring harness, Cracked PCB solder joints

Safety first: Remove the battery before inspection.

Check battery fit: Ensure the battery locks firmly in place and does not move when the vacuum is tilted.
Test behavior: With the battery installed, run the vacuum and gently tilt it in different directions. Note when it cuts off.
If cutoffs occur with slight movement: Internal wiring or PCB joints are likely loose. Continued use may worsen the damage.
Service required: Have a technician inspect and repair the internal wiring harness or main control PCB.

Hard 4/5

Internal Wiring Harness

Check Price on Amazon

We may earn a commission from links on this page.