Parkside Display / LED Board Fault

LEDs flicker or display segments fail while vacuum otherwise works

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Loose display connector, Cracked LED PCB in Parkside handle, Moisture ingress into display area, Failing LED driver components

Safety: Remove the battery before opening the handle or display housing.

Check for moisture: If the vacuum was used in a very humid environment or near liquids, allow it to dry in a warm, dry place for 24 hours.
Inspect connectors: Open the handle and locate the display PCB. Ensure the ribbon cable or connector is firmly seated.
Check PCB: Look for cracks or broken solder joints on the LED board. Replace the display PCB if damaged.
Reassemble carefully: Avoid overtightening screws that could stress the display board.

Medium 3/5

LED Display PCB

Check Price on Amazon

We may earn a commission from links on this page.