Swan Rotating Assembly Imbalance

Excessive vibration felt in hand during use

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Debris stuck in motor fan, Damaged or bent brush bar, Worn brush bar bearings, Loose floorhead or wand connection

Safety first: Remove the battery before inspection.

1. Isolate source: Run the vacuum briefly with only the main body (no wand or floorhead). If vibration disappears, the issue is in the wand or floorhead.
2. Check brush bar: Inspect for missing chunks of bristles or bent shaft. Replace if damaged.
3. Tighten connections: Ensure the wand and floorhead click firmly into place with no play.

If vibration persists in the main body alone, the main motor fan may be damaged and the motor assembly should be replaced.

Medium 3/5

Swan motorised floorhead brush bar

Check Price on Amazon

We may earn a commission from links on this page.