Vacuum makes a rattling or clunking noise from the floorhead while in use

Safety first: Turn OFF and remove the battery before working on the floorhead.

• 1. Inspect brush bar: Remove the brush bar cover and take out the brush. Check for cracks, missing bristles, or loose end caps.
• 2. Check bearings: Spin the brush bar by hand. If it feels rough or wobbly, the bearings are worn and the brush bar should be replaced.
• 3. Examine wheels: Check the front and rear wheels on the floorhead for flat spots, hair wrapped around axles, or looseness. Clean and, if necessary, replace the wheel set.
• 4. Remove debris: Shake out the floorhead and remove any small stones, screws, or hard objects that may be rattling inside.

If noise persists, consider replacing the complete Swan motorised floorhead assembly.