How to Fix / Troubleshooting

Safety first: Disconnect power and close the water tap before removing hoses.

Steps:

Check water level: After starting a cycle and allowing filling for a few minutes, open the door. Water should cover the filter area but not reach the door opening. If very low, there is a fill issue.
Inspect inlet hose: Ensure the hose is not kinked or crushed behind the machine.
Clean inlet filter: Remove the hose from the rear of the dishwasher and clean the mesh filter inside the inlet valve.
Verify water pressure: Confirm that the supply tap delivers strong flow. If pressure is low, consult a plumber.

When to call a technician: If the inlet valve or flow meter is defective, replacement may be required by a professional.

Dishwasher shows E14; may be associated with low water level or short fill conditions.

Possible Causes