E16
Blomberg Inlet Valve Stuck Open

Dishwasher shows E16; may be associated with continuous filling or water entering even when off.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Mechanically jammed inlet valve, Debris in valve seat, Electrical fault keeping valve energized, Control board output stuck on

How to Fix / Troubleshooting

Safety first: Immediately close the water supply tap and disconnect power to prevent flooding.

Steps:

  • Observe behavior: If water continues to enter the tub with power off, the valve is mechanically stuck and must be replaced.
  • Inspect inlet valve: Remove the lower front or side panel to access the valve. Check for visible damage or leaks.
  • Replace valve: Turn off water, disconnect the hose, remove electrical connectors, and unscrew the valve from the chassis. Install the new valve, reconnect hoses and wiring, and test for leaks.

When to call a technician: If the valve only opens when power is on but does not close properly, or if the control board is suspected of keeping the valve energized, professional diagnosis is recommended.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Water Inlet Valve
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements