Dishwasher displays E10; may be associated with filling or heating anomalies depending on model.

Safety first: Disconnect power before attempting any reset or inspection.

• Power reset: Turn off the dishwasher at the mains for at least 5–10 minutes to allow the control board to fully discharge. Restore power and try a short cycle.
• Check water pressure: Ensure the water supply tap is fully open and household pressure is adequate. Low pressure can cause extended fill times and trigger E10 on some Candy models.
• Inspect inlet and sensors: Clean inlet filters and verify that the pressure switch and flow meter connections are secure.
• Factory reset (if available): Some Candy dishwashers allow a service reset via button combinations (refer to the user manual). Perform this if documented for your model.
• If E10 persists: The main control board may be misconfigured or damaged. Replacement or reprogramming should be carried out by an authorized Candy service center.