E19
Candy
EEPROM / Configuration Data Error
Dishwasher shows E19; may not start or may freeze during operation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware on Candy control board, Incorrect board configuration for model, Power surge affecting memory, Internal control board failure
How to Fix / Troubleshooting
Safety first: Disconnect power before any inspection.
- Power reset: Turn off the appliance at the mains for 10–15 minutes, then restore power and attempt to start a basic program.
- Check model configuration: If the control board was recently replaced, ensure it was programmed with the correct Candy model code. Misconfigured boards can show E19.
- Service mode: Some Candy models allow reconfiguration via service mode. This should only be done with official service documentation.
- Board replacement: If E19 persists, the control board likely needs replacement or reprogramming by an authorized Candy service center.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements