Gorenje
Program Stuck / Heating or Sensor Fault Without Code
Dishwasher runs continuously for many hours and does not seem to finish the cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Water not heating to set temperature, Faulty NTC sensor drifting, Control board software glitch, Repeated fill/drain due to level sensing issues
How to Fix / Troubleshooting
Safety first: Stop the program and unplug the appliance before inspection.
- Check water temperature: During a wash, briefly open the door (after pausing) to feel the water. If it is cold, suspect a heating issue.
- Reset appliance: Cancel the program and disconnect power for 5–10 minutes, then restart a short cycle.
- Clean sensors: Clean the filters, sump, and any accessible sensors (e.g., turbidity or NTC housing) to ensure accurate readings.
- Monitor behavior: If the machine repeatedly fills and drains, a pressure switch or flow meter fault may be present and should be diagnosed.
Long-running cycles without completion often indicate a component fault; professional diagnosis may be required.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Flow-Through Heater Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements