Maidaid Program / Temperature Not Reached

Dishwasher cycles are too short and dishes are not properly washed or sanitised.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Faulty Maidaid temperature sensor, Heater not reaching setpoint, Incorrect program selection, Control board miscalibration

Safety first: Disconnect power before testing internal components.

Verify program: Ensure the correct Maidaid program is selected for the load and hygiene requirements.
Check temperature: Measure water temperature during wash and final rinse with a thermometer. Compare with Maidaid specifications.
Investigate heating: If temperatures are low, test the heater and NTC sensor as per heating fault procedures.
Control calibration: If hardware is OK but cycles remain short, a technician may need to update or recalibrate the control PCB.

Hard 4/5

Maidaid Control PCB

Check Price on Amazon

We may earn a commission from links on this page.