Asko
Motor Overheating / Thermal Protector Tripping
Dryer runs for a few minutes then shuts off and will not restart until it cools down.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failing drive motor, Blocked blower wheel, Excessive drum friction from worn rollers or bearings, Restricted airflow causing high internal temperature
How to Fix / Troubleshooting
Safety first: Unplug the dryer and allow it to cool.
Steps:
- Check ventilation: Ensure exhaust vent and lint filter are clean to reduce internal heat.
- Inspect drum supports: Check rollers, idler, and drum bearings for drag. Replace worn parts.
- Blower inspection: Verify that the blower wheel is clean and spins freely.
- Motor evaluation: If mechanical components are free and the problem persists, the motor's internal thermal protector may be tripping due to motor failure. Replacement of the motor is usually required.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements