E11
Asko
Exhaust Temperature Sensor Fault
Dryer shows E11; may stop heating or terminate cycle prematurely.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed exhaust NTC sensor, Damaged sensor wiring, Sensor shorted by moisture or lint, Faulty control board input
How to Fix / Troubleshooting
Safety first: Disconnect power before servicing.
Steps to diagnose exhaust sensor:
- Locate exhaust NTC: Typically mounted on the exhaust duct or heater outlet area.
- Check connections: Inspect the sensor plug and wiring harness for damage or loose fit. Clean any lint or debris around the sensor.
- Test resistance: Remove the sensor and measure resistance at room temperature and, if possible, in warm water. Compare to Asko's resistance/temperature chart. Replace if readings are abnormal.
- Board evaluation: If the sensor and wiring are good, the main control board may misread the sensor and need replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Exhaust Temperature Sensor (NTC)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements