Dryer shows E19; may not respond correctly to selected programs.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Corrupted control board firmware, Power surge, Incorrect configuration settings, Faulty EEPROM on PCB

Safety first: Unplug the dryer before extended resets.

Steps:

Power reset: Disconnect power for at least 10–15 minutes to allow capacitors to discharge, then reconnect and test.
Factory reset: If your Asko model supports a user-accessible factory reset (refer to user manual), perform it to restore default program settings.
Check for updates: Some newer models may support firmware updates via service tools; this must be done by an authorized technician.

If E19 persists, the main control board likely requires replacement.

Professional Required 5/5

Main Control Board (PCB)

Check Price on Amazon

We may earn a commission from links on this page.