E16
Balay
Door Open Detection Fault
Dryer shows E16; may be associated with door open detection during cycle
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Intermittent door switch, Loose door lock connector, Misaligned door causing vibration-induced opening, Control board input fault
How to Fix / Troubleshooting
Safety first: Disconnect mains power before working on the door system.
Steps to check and fix:
- Check door alignment: Ensure the door closes squarely and the hinge screws are tight. Adjust hinges if the door sags.
- Inspect the latch and strike: Replace worn or damaged latch hooks that may allow the door to open slightly during operation.
- Test the door switch: Access the door lock assembly and test the switch with a multimeter while opening and closing the door. Replace the lock if readings are intermittent.
- Secure connectors: Reseat the door lock connector on both the lock and PCB ends.
- Test cycle: Reassemble and run a cycle. If E16 persists with a good lock and alignment, the control board input circuit may be defective.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements