Dryer shows E09 and will not start or stops shortly after starting; often related to power supply or control issues.

Safety first: Disconnect the dryer from mains. Only persons competent with electrical safety should open the control panel.

• Check mains outlet: Test the wall socket with another appliance to confirm stable power. Avoid using long extension leads or multi-way adaptors.
• Inspect mains cable and terminal block: Remove the rear cover over the mains terminal block. Check for loose screws, burnt insulation, or discoloration. Tighten connections and replace damaged parts.
• Examine control board: Access the main PCB (usually behind the control fascia or side panel). Look for burnt components, bulging capacitors, or damaged tracks.
• Reset power: After inspection, reconnect and try a power reset by unplugging for 5–10 minutes, then plugging back in.
• If E09 persists and visible PCB damage is present: Replace the main control board with the exact Beko part number. This is best performed by a professional to avoid miswiring.