E18
Gorenje
Configuration / Calibration Error
Dryer displays E18; may be associated with sensor calibration or configuration issues.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect parameter settings in control board, Failed self-calibration of sensors, Corrupted firmware, Replacement PCB not programmed for model
How to Fix / Troubleshooting
Safety first: Unplug the dryer before opening any panels.
- Power cycle: Disconnect power for several minutes, then reconnect and see if the error clears.
- Check model compatibility: If a control board was recently replaced, verify that it is the correct Gorenje part number for your exact dryer model.
- Run service calibration (if available): Some models allow entering a service mode to recalibrate sensors (refer to service documentation). This should be done by a trained technician.
- Firmware issues: If the error appeared after a power surge, the firmware may be corrupted. Control board replacement is typically required.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements