Gram
Cool-Down Phase Not Operating
Dryer stops with clothes hot and very wrinkled; no error code.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Heater stuck on due to relay fault, Faulty temperature sensor, Software issue in main control PCB, Blocked airflow causing high exit temperature
How to Fix / Troubleshooting
Safety first: Unplug the dryer and allow it to cool before inspection.
- Check airflow: Clean lint filter, ducts, and condenser to ensure proper cooling airflow during the final phase.
- Monitor heater operation: During a test cycle, verify that the heater turns off near the end of the program. If it stays on continuously, the heater relay on the PCB may be stuck and the board should be replaced.
- Test temperature sensor: Check NTC sensor resistance and replace if faulty.
- Use appropriate program: Ensure you are using a program with a cool-down phase and not a timed high-heat only program.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Heater Relay (on Main Control PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements