Vedette Program Logic / Sensor Dependency Issue

Dryer runs only on some programs; other programs will not start or end immediately

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Faulty moisture sensor affecting sensor-dry programs, Incorrect program selection for load, Partial control board failure on specific program outputs

Safety first: Unplug the dryer before sensor or board inspection.

Step-by-step checks:

Test timed programs: Run a timed (non-sensor) program. If it works normally, the issue is likely with moisture sensing.
Clean moisture sensors: Clean the sensor bars inside the drum thoroughly.
Observe behavior: If only one or two specific programs fail, the control board may have a partial fault and require replacement.

Medium 3/5

Moisture Sensor / Main Control Board

Check Price on Amazon

We may earn a commission from links on this page.